|
|
PDF V500DK1-KS1 Data sheet ( Hoja de datos )
| Número de pieza | V500DK1-KS1 | |
| Descripción | TFT LCD Module | |
| Fabricantes | CMI MEI | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de V500DK1-KS1 (archivo pdf) en la parte inferior de esta página. Total 30 Páginas | ||
|
No Preview Available !
WZKhd ^W /&/ d/KE
ϭ Tentative Specification
ϭ Preliminary Specification
Ϯ Approval Specification
MODEL NO.: V500DK1
SUFFIX: KS1
Ƶ Ɛ ƚ Ž ŵ Ğ ƌ ͗
WWZK s z
^ /' E d h Z
EĂŵĞ ͬ dŝƚůĞ
EŽ ƚĞ
WůĞĂƐĞ ƌĞƚƵƌŶ ϭ ĐŽƉLJ ĨŽƌ LJŽƵƌ ĐŽŶĨŝƌŵĂƚŝŽŶ ǁŝƚŚ LJŽƵƌ ƐŝŐŶĂƚƵƌĞ ĂŶĚ
ĐŽŵŵĞŶƚƐ͘
Approved By
Chao-Chun
Chung
Checked By
Carlos Lee
Prepared By
Archer Chang
sĞƌƐŝŽŶ Ϯ͘ Ϭ
ϭ Ă ƚ Ğ ϭϭ K Đ ƚ ͘ ϮϬ ϭϮ
dŚĞ ĐŽ Ɖ LJ ƌ ŝ Ő Śƚ ď Ğů Ž Ŷ Ő Ɛ ƚ Ž ,/ D / / Ŷ Ŷ Ž > Ƶ dž ͘ Ŷ LJ Ƶ Ŷ Ă Ƶ ƚ ŚŽ ƌ ŝ nj ĞĚ Ƶ Ɛ Ğ ŝ Ɛ Ɖ ƌ Ž Śŝ ď ŝ ƚ ĞĚ
1 page  
WZKhd ^W /&/ d/KE
1. GENERAL DESCRIPTION
1.1 OVERVIEW
V500DK1-KS1 is a 50” TFT Liquid Crystal Display module with LED Backlight unit and 16Lane V-by-one
interface. This module supports 3840 x 2160 QFHDTV format and can display true 1.07G colors (8-bit+FRC
/color). The driving board module for backlight is built-in.
1.2 FEATURES
- High brightness 400 nits
- High contrast ratio 5000:1
- Fast response time Gray to Gray typical 6.5ms
- High color saturation 72% NTSC
- QFHDTV (3840 x 2160 pixels) resolution, true QFHDTV format
- DE (Data Enable) only mode
- V-by-One interface
- Optimized response time for 120 Hz frame rate
- Ultra wide viewing angle: Super MVA technology
ˀ RoHs compliance
1.3 APPLICATION
- Standard Living Room TVs.
- Public Display Application.
- Home Theater Application.
- 3D Application.
1.4 GENERAL SPECIFICATI0NS
Item
Active Area
Bezel Opening Area
Specification
1095.84(H) x (V) 616.41 (50” diagonal)
1103.04(H) x 622.41(V)
Unit Note
mm
(1)
mm
Driver Element
a-si TFT active matrix
--
Pixel Number
3840 x R.G.B. x 2160
pixel
-
Pixel Pitch(Sub Pixel)
0.0955(H) x 0.2865(V)
mm -
Pixel Arrangement
Display Colors
Display Operation Mode
RGB vertical stripe
1.07G
Transmissive mode / Normally black
-
color
-
-
-
-
Surface Treatment
Anti-Glare coating (Haze 1%),Hardness 3H - (2)
Rotation Function
Unachievable
(3)
Note (1) Please refer to the attached drawings in chapter 9 for more information about the front and
back outlines.
Note (2) The spec of the surface treatment is temporarily for this phase. CMI reserves the rights to
change this feature.
sĞƌƐŝŽŶ Ϯ͘ Ϭ
ϱ Ă ƚ Ğ ϭϭ K Đ ƚ ͘ ϮϬ ϭϮ
dŚĞ ĐŽ Ɖ LJ ƌ ŝ Ő Śƚ ď Ğů Ž Ŷ Ő Ɛ ƚ Ž ,/ D / / Ŷ Ŷ Ž > Ƶ dž ͘ Ŷ LJ Ƶ Ŷ Ă Ƶ ƚ ŚŽ ƌ ŝ nj ĞĚ Ƶ Ɛ Ğ ŝ Ɛ Ɖ ƌ Ž Śŝ ď ŝ ƚ ĞĚ
5 Page 
WZKhd ^W /&/ d/KE
3.2 BACKLIGHT UNIT
3.2.1 LED LIGHT BARCHARACTERISTICS (Ta = 25 ± 2 ºC)
Th e b a c k l i g h t u n i t c o n t a i n s 2 p c s LE D l i g h t b a r , a n d e a c h l i g h t b a r h a s 8 s t r i n g LE D
Pa r a m e t e r
Sym bol
M in .
Va l u e
Ty p .
M ax.
U n it
On e S t r i n g Cu r r e n t
On e S t r i n g Vo l t a g e
On e S t r i n g Vo l t a g e Va r i a t i o n
Li f e t i m e
IL(2D)
IL(3 D)
VW
ϦVW
-
117.5
376
40
-
30 ,0 0 0
125
40 0
-
-
-
133 m A
424 m Ap e a k
47 VDC
2V
- Hr s
No t e
(1)
3D E NA= ON
IL = 125m A
(2)
Note (1) D imming R atio= 10 0 %
Note (2) The lif etime is def ined as the time whic h luminanc e of the L E D dec ays to 50 % c ompared to the initial value,
O perating c ondition: C ontinuous operating at Ta = 25± 2к, IL = 125mA .
3.2.2 CONVERTER CHARACTERISTICS (Ta = 25 ± 2 ºC)
Pa r a m e t e r
Sym bol
M in .
Va l u e
Ty p .
M ax.
U n it
No t e
Po w e r Co n s u m p t i o n
PB L(2D)
PB L(3 D)
Ё
Ё
94.7 10 5 W (1), (2), IL= 125 m A
85 96 W (1), (2), IL= 40 0 m A
Co n v e r t e r In p u t Vo l t a g e
VB L
22.8
24.0
25.2 VD C
Co n v e r t e r In p u t Cu r r e n t
In p u t In r u s h Cu r r e n t
IB L(2D)
IB L(3 D)
IR ( 2 D )
IR (3 D)
Ё
Ё
Ё
Ё
3.95 4.37 A No n D i m m i n g
3.54 4 A
Ё
7.7
VB L= 22.8V, (IL= t y p .)
Apeak
(3), (6)
Ё
14
VB L= 22.8V,(IL= 360
Apeak
m A.) (3), (6)
D im m in g F re q u e n c y
FB
170
180
19 0 H z
(5)
D im m in g D u ty R a tio
DDR
5
-
10 0 %
(4), (5)
Note (1) The power supply c apac ity should be higher than the total c onverter power c onsumption PB L. S inc e the pulse
width modulation (PWM ) mode was applied f or bac k light dimming, the driving c urrent c hanged as PWM
duty on and of f . The transient response of power supply should be c onsidered f or the c hanging loading
when c onverter dimming.
Note (2) The measurement c ondition of M ax . value is based on 50 " bac k light unit under input voltage 24V , average
L E D c urrent 133 mA at 2D M ode (L E D c urrent 424 mA p e a k at 3D M ode) and lighting 1 hour later.
sĞƌƐŝŽŶ Ϯ͘ Ϭ
ϭϭ Ă ƚ Ğ ϭϭ K Đ ƚ ͘ ϮϬ ϭϮ
dŚĞ ĐŽ Ɖ LJ ƌ ŝ Ő Śƚ ď Ğů Ž Ŷ Ő Ɛ ƚ Ž ,/ D / / Ŷ Ŷ Ž > Ƶ dž ͘ Ŷ LJ Ƶ Ŷ Ă Ƶ ƚ ŚŽ ƌ ŝ nj ĞĚ Ƶ Ɛ Ğ ŝ Ɛ Ɖ ƌ Ž Śŝ ď ŝ ƚ ĞĚ
11 Page | ||
| Páginas | Total 30 Páginas | |
| PDF Descargar | [ Datasheet V500DK1-KS1.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| V500DK1-KS1 | TFT LCD Module | CMI MEI |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |