|
|
PDF SVA260WX01SA Data sheet ( Hoja de datos )
| Número de pieza | SVA260WX01SA | |
| Descripción | TFT COLOR LCD MODULE | |
| Fabricantes | NEC | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de SVA260WX01SA (archivo pdf) en la parte inferior de esta página. Total 30 Páginas | ||
|
No Preview Available !
Global LCD Panel Exchange Center
www.panelook.com
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
1 page  
Global LCD Panel Exchange Center
www.panelook.com
SN-SA-A0030-02-E
2. GENERAL INFORMATION (under normal temperature)
5/43
Display area
Display diagonal
Drive system
Display color
Pixel
Pixel arrangement
Dot pitch
Pixel pitch
Module size
Weight
Contrast ratio
Viewing angle
Designed viewing direction
Polarizer surface treatment
Polarizer pencil hardness
Color gamut
Response time
Luminance
Signal system
Power supply voltage
Backlight
Power consumption
575.77(H) x 323.71 (V) mm (typ.)
66.0 cm (26.0 inches)
a-Si TFT active matrix
16.77M colors (8bit)
1,366 (H) ×768(V) pixels
RGB (Red dotǃGreen dotǃ Blue dot) vertical stripe
0.1405(H)×0.4215(V) mm
0.4215(H)×0.4215(V) mm
626.0(typ., W) ×373.0( typ., H) ×48.0(max., D) mm
˄4,800 g˅ (typ.)
550:1(typ.)
Contrast ratio ı 10˖1
• Horizontal: right 85° (typ.) , left 85° (typ.)
• Vertical: up 85° (typ.) , down 85° (typ.)
Viewing angle with optimum grayscale (Ȗ=2.2): normal axis
Anti-glare (AGS2B)
3H (min.)
At LCD panel center
72 % (typ.) [against NTSC color space]
Ton + Toff (10%ĕė90%)
16 ms (typ.)
At IBL = 5.2 mArms / lamp
500cd/m2 (typ.)
LVDS 1 port
[ RGB :8-bit, Dot clock (CLK), Data enable (DE)]
LCD panel signal processing board˖5.0V
LCD backlight : 24.0V
Direct type˖cold cathode fluorescent lamps.
14 piece pipes(with inverter)
Replaceable part: Inverter board 260PW011S-B
Luminance to maximum and at sub pixel check (0/255) pattern
90 W (typ.)
2
2
Not duplication without authorization
Shanghai SVA NEC Liquid Crystal Display Co., Ltd.
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
5 Page 
Global LCD Panel Exchange Center
www.panelook.com
SN-SA-A0030-02-E 11/43
4.4 POWER SUPPLY VOLTAGE SEQUENCE AND RIPPLE
4.4.1 Power supply voltage and B/L control sequence
VCC(Note 1)
0V
Display signal (Note 2)
Function signal
ON
(t˘20ms) * 1
OFF
(0.5V)
(4.5V)
(0˘Trİ30ms)
(4.5V)
(4.0V)
90%
0V
VALID
(0˘tİ50ms)
(Toff ˚300ms)
90%
(0˘tİ50ms)
VDDB
Ć: The signal line is not connected with the module, at the end of cable the terminal resistor of 100 should
be added.
Note 1: In terms of voltage variation (voltage drop) while VCC rising edge is below 4.5V, a protection circuit may
work, and then this product may not work.
Note2: In order not to damage the inner circuit, display signals (D0+/-, D1+/-, D2+/-, D3+/- and CK+/-)must
apply low or high impedance, exclude the VALID period (See above sequence diagram).
If some of display and function signals of this product are cut while this product is working, even if the
signal input to it once again, it might not work normally. If customer stops the display and function signals,
they should cut VCC.
Note3: When VDD is on, it should be set above 4.5V.
Note4: The backlight power supply voltage should be inputted within the valid period of display and function
signals, in order to avoid unstable data display.
4.4.2 Backlight timing
Voltage
24.0V
23.0V
İ800ms
BRTC
VDDB
0˘t 0˘t Time
Note1: In order to prevent unstable data displaying, inverter’s power supply voltage should be input in the valid
period of LVDS signals.
Note2:If the time for VDDB to start up is over 800ms,inverter’s protection circuit will work, and then backlight
will not be on.
Not duplication without authorization
Shanghai SVA NEC Liquid Crystal Display Co., Ltd.
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
11 Page | ||
| Páginas | Total 30 Páginas | |
| PDF Descargar | [ Datasheet SVA260WX01SA.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| SVA260WX01SA | TFT COLOR LCD MODULE | NEC |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |