DataSheet.es    


PDF NL10276BC30-18C Data sheet ( Hoja de datos )

Número de pieza NL10276BC30-18C
Descripción TFT COLOR LCD MODULE
Fabricantes NEC 
Logotipo NEC Logotipo



Hay una vista previa y un enlace de descarga de NL10276BC30-18C (archivo pdf) en la parte inferior de esta página.


Total 29 Páginas

No Preview Available ! NL10276BC30-18C Hoja de datos, Descripción, Manual

TFT COLOR LCD MODULE
NL10276BC30-18C
38cm (15.0 Type)
XGA
LVDS Interface (1port)
DATA SHEET
DOD-PP-0327 (2nd edition)
This DATA SHEET is updated document from
DOD-PP-0159(1).
All information is subject to change without notice.
Please confirm the sales representative before
starting to design your system.
Document Number: DOD-PP-0327 (2nd edition)
Published date: July 2007 CP(N)
1 © NEC LCD Technologies, Ltd.
2007 All rights reserved.

1 page




NL10276BC30-18C pdf
NL10276BC30-18C
2. GENERAL SPECIFICATIONS
Display area
Diagonal size of display
Drive system
Display color
Pixel
Pixel arrangement
Dot pitch
Pixel pitch
Module size
Weight
Contrast ratio
Viewing angle
Designed viewing direction
Polarizer surface
Polarizer pencil-hardness
304.128 (H) × 228.096 (V) mm
38cm (15.0 inches)
a-Si TFT active matrix
16,777,216 colors (6bit+FRC)
1,024 (H) × 768 (V) pixels
RGB (Red dot, Green dot, Blue dot) vertical stripe
0.099 (H) × 0.297 (V) mm
0.297 (H) × 0.297 (V) mm
326.5 (typ., W) × 253.5 (typ., H) × 17.0 (max., D) mm
1,300g (typ.)
600:1 (typ.)
At the contrast ratio 10:1
Horizontal: Right side 80° (typ.), Left side 80° (typ.)
Vertical: Up side 80° (typ.), Down side 60° (typ.)
At DPS terminal= Low or Open: Normal scan
Viewing direction without image reversal: up side (12 o'clock)
Viewing direction with contrast peak: down side (6 o'clock)
Viewing angle with optimum grayscale (γ=2.2): normal axis (perpendicular)
Clear + Antireflection (AR)
2H (min.) [by JIS K5400]
Color gamut
At LCD panel center
40% (typ.) [against NTSC color space]
Response time
Ton+Toff (10%←→ 90%)
18ms (typ.)
Luminance
At IBL=6.0mArms / lamp
600cd/m2 (typ.)
Signal system
LVDS 1port (Receiver: Equivalent of THC63LVDF84B, THine Electronics Inc.)
[8-bit digital signals for data of RGB colors, Dot clock (CLK),
Data enable (DE)]
Power supply voltage
LCD panel signal processing board: 3.3V
Edge light type: 4 cold cathode fluorescent lamps (without inverter)
Backlight
Replaceable part
Lamp holder set: Type No. 150LHS29
Power consumption
Recommended inverter (Option)
Inverter: Type No. 150PW231
At IBL= 6.0mArms / lamp, Checkered flag pattern
15.7W (typ., Power dissipation of the inverter is not included.)
DATA SHEET DOD-PP-0327 (2nd edition)
5

5 Page





NL10276BC30-18C arduino
NL10276BC30-18C
4.4 POWER SUPPLY VOLTAGE SEQUENCE
4.4.1 LCD panel signal processing board
ON
VCC
3.0V
Note1
0V
0.1ms < Tr < 80ms
OFF
2.5V 3.0V
20ms max.
ON
Toff > 200ms
Display signals*,
Function signals
Note2
0V
0ms < t < 50ms
VALID period
0ms < t < 50ms
* These signals should be measured at the terminal of 100Ω resistance.
Note1: In terms of voltage variation (voltage drop) while VCC rising edge is below 3.0V, a
protection circuit may work, and then this product may not work.
Note2: Display signals (D0+/-, D1+/-, D2+/-, D3+/- and CLK+/-) and function signals (MSL and
DPS) must be Low or High impedance, exclude the VALID period (See above sequence
diagram), in order to avoid that internal circuit is damaged.
If some of display and function signals of this product are cut while this product is working,
even if the signal input to it once again, it might not work normally. VCC should be cut
when the display and function signals are stopped.
4.4.2 Inverter (Option)
Display signals,
Function signals
Note1
Note2
VALID period
VDDB
Note1: These are the display and function signals for LCD panel signal processing board.
Note2: The backlight should be turned on within the valid period of display and function signals, in
order to avoid unstable data display.
DATA SHEET DOD-PP-0327 (2nd edition)
11

11 Page







PáginasTotal 29 Páginas
PDF Descargar[ Datasheet NL10276BC30-18C.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
NL10276BC30-18LCD ModuleNEC
NEC
NL10276BC30-18CTFT COLOR LCD MODULENEC
NEC

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar