DataSheet.es    


PDF ICR18650-30B Data sheet ( Hoja de datos )

Número de pieza ICR18650-30B
Descripción Lithium-ion Rechargeable Cell
Fabricantes Samsung 
Logotipo Samsung Logotipo



Hay una vista previa y un enlace de descarga de ICR18650-30B (archivo pdf) en la parte inferior de esta página.


Total 17 Páginas

No Preview Available ! ICR18650-30B Hoja de datos, Descripción, Manual

-SAMSUNG SDI Confidential Proprietary
Spec. No. ICR18650-30B Version No.
1.1
SPECIFICATION OF PRODUCT
for Lithium-ion Rechargeable Cell
Model : ICR18650-30B
Feb., 2010
Samsung SDI Co. , Ltd.
Energy Business Division
0
http://www.Datasheet4U.com

1 page




ICR18650-30B pdf
-SAMSUNG SDI Confidential Proprietary
Spec. No. ICR18650-30B Version No.
1.1
Charge Temperature
25
Relative Capacity
-10
50%
Discharge temperature
025
80%
100%
40
80%
Note: If charge temperature and discharge temperature is not the same,
the interval for temperature change is 3 hours.
Percentage as an index of the capacity at 25(=2850mAh) is 100%.
7.5 Temperature Dependence of Charge Capacity
Capacity comparison at each temperature, measured with discharge constant current
590mA and 2.75V cut-off after the standard charge is as follows.
Relative Capacity
Charge temperature
0
25
45
80%
100%
80%
Discharge temperature
25
Note: If charge temperature and discharge temperature is not the same,
the interval for temperature change is 3 hours.
Percentage as an index of the capacity at 25(=2850mAh) is 100%.
7.6 Charge Rate Capabilities
Discharge capacity is measured with constant current 590mA and 2.75V cut-off
after the cell is charged with 4.35V as follows.
Current
Cut-off
Relative
Capacity
0.2C
(590mA)
7h or 0.05C
100%
Charge Condition
0.5C
(1475mA)
3.0h or 0.05C
95%
1.0C
(2950mA)
2.5h or 0.05C
90%
Note: Percentage as an index of the capacity at 25(=2850mAh) is 100%.
7.7 Discharge Rate Capabilities
Discharge capacity is measured with the various currents in under table and 2.75V
cut-off after the standard charge.
4

5 Page





ICR18650-30B arduino
-SAMSUNG SDI Confidential Proprietary
Spec. No. ICR18650-30B Version No.
1.1
the product specification.
3.2.2 Otherwise, it may cause loss of characteristics.
3.3 Over-discharging
3.3.1 The system should equip with a device to prevent further discharging
exceeding discharging cut-off voltage specified in the product
specification. (over-discharging)
3.3.2 Over-discharging may cause loss of performance, characteristics, of
battery function.
3.3.3 Over-discharging may occur by self-discharge if the battery is left for
a very long time without any use.
3.3.4 The charger should equip with a device to detect cell voltage and to
determine recharging procedures.
4. Storage
4.1 Storage conditions
4.1.1 The cell should be stored within a range of temperatures specified
in the product specification.
4.1.2 Otherwise, it may cause loss of characteristics, leakage and/or rust.
4.2 Long-term storage
4.2.1 The cell should be used within a short period after charging because
long-term storage may cause loss of capacity by self-discharging.
4.2.2. If long-term storage is necessary, the cell should be stored at lower
voltage within a range specified in the product specification, because
storage at higher voltage may cause loss of characteristics.
5. Cycle life
5.1 Cycle life performance
5.1.1 The cell can be charged/discharged repeatedly up to times specified in
the produce specification with a certain level of capacity also specified
in the product specification.
5.1.2 Cycle life may be determined by conditions of charging, discharging,
operating temperature and/or storage.
6. Design of System
6.1 Connection between the cell and the battery
6.1.1 The cell should not be soldered directly with leads. Namely, the cell
should be welded with leads on its terminal and then be soldered with
wire or leads to soldered lead.
6.1.2 Otherwise, it may cause damage of component, such as separator and
insulator, by heat generation.
10

11 Page







PáginasTotal 17 Páginas
PDF Descargar[ Datasheet ICR18650-30B.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
ICR18650-30Afor Lithium-ion Rechargeable CellSamsung
Samsung
ICR18650-30BLithium-ion Rechargeable CellSamsung
Samsung

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar