DataSheet.es    


PDF DM9374 Data sheet ( Hoja de datos )

Número de pieza DM9374
Descripción 7-Segment Decoder/Driver/Latch
Fabricantes Fairchild Semiconductor 
Logotipo Fairchild Semiconductor Logotipo



Hay una vista previa y un enlace de descarga de DM9374 (archivo pdf) en la parte inferior de esta página.


Total 8 Páginas

No Preview Available ! DM9374 Hoja de datos, Descripción, Manual

March 1989
Revised March 2000
DM9374
7-Segment Decoder/Driver/Latch
with Constant Current Sink Outputs
General Description
The DM74 is a 7-segment decoder driver incorporating
input latches and output circuits to directly drive common
anode LED displays.
Ordering Code:
Order Number Package Number
Package Description
DM9374N
N16E
16-Lead Plastic Dual-In-Line Package (PDIP), JEDEC MS-001, 0.300 Wide
Connection Diagram
Logic Symbol
Pin Descriptions
VCC = Pin 16
GND = Pin 8
Pin
Names
A0–A3
LE
RBI
RBO
a –g
Description
Address (Data Inputs)
Latch Enable Input (Active LOW)
Ripple Blanking Input (Active LOW)
Ripple Blanking as Output (Active LOW)
as Input (Active LOW)
Constant Current Outputs (Active LOW)
© 2000 Fairchild Semiconductor Corporation DS010210
www.fairchildsemi.com
http://www.Datasheet4U.com

1 page




DM9374 pdf
Low Power, Low Cost Display Power Sources—In small
line operated systems using TTL/MSI and LED or incan-
descent displays, a significant portion of the total dc power
is consumed to drive the displays. Since it is irrelevant
whether displays are driven from unfiltered dc or pulsed dc
(at fast rates), a dual power system can be used that
makes better utilization of transformer rms ratings. The
system utilizes a full wave rectified but unsmoothed dc volt-
age to provide the displays with 120 Hz pulsed power while
the reset of the system is driven by a conventional dc
power circuit. The frequency of 120 Hz is high enough to
avoid display flicker problems. The main advantages of this
system are:
• Reduced transformer rating
• Much smaller smoothing capacitor
• Increased LED light output due to pulsed operation
With the standard capacitor filter circuit, the rms current
(full wave) loading of the transformer is approximately
twice the dc output. Most commercial transformer manu-
facturers rate transformers with capacitive input filters as
follows:
Full Wave Bridge Rectifier Circuit
Transformer rms current = 1.8 x dc current required
Full Wave Center Tapped Rectifier Circuit
Transformer rms current = 1.2 x dc current required
Therefore, the removal of a large portion of the filtered dc
current requirement (display power) substantially reduces
the transformer loading.
There are two basic approaches. First (Figure 3) is the
direct full wave rectified unregulated supply to power the
displays. The '74 decoder driver constant current feature
maintains the specified segment current after the LED
diode drop and 0.5V saturation voltage has been reached
(2.2V). Care must be exercised not to exceed the '74
power ratings and the maximum voltage that the decoder
driver sees in both the “on” and “off” modes.
The second approach (Figure 4) uses a 3-terminal voltage
regulator such as the 7805 to provide dc pulsed power to
the display with the peak dc voltage limited to +5.0V. This
approach allows easier system thermal management by
heat sinking the regulator rather than the display or display
drivers. When this power source is used with an intensity
modulation scheme or with a multiplexed display system,
the frequencies must be chosen such that they do not beat
with the 120 Hz full wave rectified power frequency.
FIGURE 3. Direct Unregulated Display Supply
FIGURE 4. Pulsed Regulated Display Supply
5
www.fairchildsemi.com
http://www.Datasheet4U.com

5 Page










PáginasTotal 8 Páginas
PDF Descargar[ Datasheet DM9374.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
DM93747-Segment Decoder/Driver/LatchNational Semiconductor
National Semiconductor
DM93747-Segment Decoder/Driver/LatchFairchild Semiconductor
Fairchild Semiconductor

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar