|
|
PDF PS21265-P Data sheet ( Hoja de datos )
| Número de pieza | PS21265-P | |
| Descripción | Dual-In-Line Package Intelligent Power Module | |
| Fabricantes | Mitsubishi | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de PS21265-P (archivo pdf) en la parte inferior de esta página. Total 10 Páginas | ||
|
No Preview Available !
PS21265
MITMSUITBSIUSBHISSHEIMSIECMOINCDOUNCDTUOCRTO<RDu<aDl-uIna-lL-Iinn-eLiPnaecPkacgkeaIgneteIlnlitgeellnigtePnotwPeorwMeor dMuoled>ule>
PS212P6S52-1P26/5A-PP/AP
TRATNRSAFNESRF-EMRO-MLDOLTDYPTEYPE
INSIUNLSAUTLEADTETDYPTEYPE
INTEGRATED POWER FUNCTIONS
600V/20A low-loss 5th generation IGBT inverter bridge for
three phase DC-to-AC power conversion
INTEGRATED DRIVE, PROTECTION AND SYSTEM CONTROL FUNCTIONS
• For upper-leg IGBTS :Drive circuit, High voltage high-speed level shifting, Control supply under-voltage (UV) protection.
• For lower-leg IGBTS : Drive circuit, Control supply under-voltage protection (UV), Short circuit protection (SC).
• Fault signaling : Corresponding to an SC fault (Lower-side IGBT) or a UV fault (Lower-side supply).
• Input interface : 3, 5V line compatible. (High Active)
• UL Approved : Yellow Card No. E80276
APPLICATION
AC100V~200V three-phase inverter drive for small power motor control.
Fig. 1 PACKAGE OUTLINES (Short-pin type : PS21265-P)
2.8±0.3
27×2.8(=75.6)
1 2 3 4 5 6 7 8 9 10 11 12 13
14 15 16 17 18 19 20 21
2-φ4.5±0.2
Type name , Lot No.
Refer Fig. 6 for long-pin type : PS21265-AP.
Dimensions in mm
NOTE
D Heat sink side
TERMINAL CODE
1. UP
2. VP1
3. VUFB
4. VUFS
5. VP
6. VP1
7. VVFB
8. VVFS
9. WP
10. VP1
11. VPC
12. VWFB
13. VWFS
14. VN1
15. VNC
16. CIN
17. CFO
18. FO
19. UN
20. VN
21. WN
22. P
23. U
24. V
25. W
26. N
22 23 24 25
10±0.3 10±0.3 10±0.3
67±0.3
79±0.5
B
26
20±0.3
C
A
3.8±0.2
1±0.2
C0.2
1±0.2
0.7±0.2
0.7±0.2
C0.2
0.8±0.2
0.8±0.2
0.45±0.2
0.8±0.2
0.45±0.2
0.45±0.2
(71)
Heat sink side
(2.5)
OTHERS
TERMINAL 22, 26
DETAIL B
(5 pins t = 0.7)
OTHERS
TERMINAL 1-2, 20-21
DETAIL C
(21 pins t = 0.7)
0.5±0.2
DETAIL A
DETAIL D
Note: All outer lead terminals are with Pb-free solder plating.
Oct. 2005
Free Datasheet http://www.datasheet4u.com/
1 page  
MITSUBISHI SEMICONDUCTOR <Dual-In-Line Package Intelligent Power Module>
PS21265-P/AP
TRANSFER-MOLD TYPE
INSULATED TYPE
MECHANICAL CHARACTERISTICS AND RATINGS
Parameter
Mounting torque
Weight
Heat-sink flatness
Note 6 :
Condition
Mounting screw : M4
Recommended : 1.18 N·m
(Note 6)
Min.
0.98
—
–50
Limits
Typ.
—
54
—
Max.
1.47
—
100
Unit
N·m
g
µm
+–
Heat sink
Measurement point
–
+
3mm
Place to contact
a heat sink
Heat sink
RECOMMENDED OPERATION CONDITIONS
Symbol
Parameter
Condition
Recommended value
Min. Typ. Max.
Unit
VCC
VD
VDB
∆VD, ∆VDB
tdead
fPWM
Supply voltage
Control supply voltage
Control supply voltage
Control supply variation
Arm shoot-through blocking time
PWM input frequency
Applied between P-N
Applied between VP1-VPC, VN1-VNC
Applied between VUFB-VUFS, VVFB-VVFS, VWFB-VWFS
For each input signal, TC ≤ 100°C
TC ≤ 100°C, Tj ≤ 125°C
0
13.5
13.0
–1
2
—
300
15.0
15.0
—
—
—
400 V
16.5
V
18.5
V
1 V/µs
— µs
20 kHz
IO Allowable r.m.s. current
PWIN(on)
Minimum input pulse width
PWIN(off)
VCC = 300V, VD = VDB = 15V, fPWM = 5kHz
P.F = 0.8, sinusoidal PWM
TC ≤ 100°C, Tj ≤ 125°C (Note 7) fPWM = 15kHz
(Note 8)
200 ≤ VCC ≤ 350V,
13.5 ≤ VD ≤ 16.5V,
Below rated current
13.0 ≤ VDB ≤ 18.5V,
–20°C ≤ TC ≤ 100°C,
Between rated current and
1.7 times of rated current
N-line wiring inductance less Between 1.7 times and
than 10nH
(Note 9) 2.0 times of rated current
—
—
0.3
1.4
2.5
3.0
— 14.0
Arms
— 9.5
——
——
— — µs
——
VNC VNC variation
between VNC-N (including surge)
–5.0
—
5.0
V
Note 7 : The Allowable r.m.s. current value depends on the actual application conditions.
8 : Input signal with ON pulse width less than PWIN(on) might make no response.
9 : IPM might make no response or response delay to next turn-on pulse if off-pulse width is less than PWIN(off). (Please refer to Fig. 4)
Please refer to Fig. 9 for recommended wiring method too.
Oct. 2005
Free Datasheet http://www.datasheet4u.com/
5 Page | ||
| Páginas | Total 10 Páginas | |
| PDF Descargar | [ Datasheet PS21265-P.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| PS21265-AP | Dual-In-Line Intelligent Power Module |  Powerex |
| PS21265-AP | Dual-In-Line Package Intelligent Power Module | Mitsubishi |
| PS21265-P | Dual-In-Line Intelligent Power Module | Powerex |
| PS21265-P | Dual-In-Line Package Intelligent Power Module | Mitsubishi |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |