Datenblatt-pdf.com


RZ600 Schematic ( PDF Datasheet ) - ATMEL Corporation

Teilenummer RZ600
Beschreibung 8-bit AVR Microcontrollers
Hersteller ATMEL Corporation
Logo ATMEL Corporation Logo 




Gesamt 18 Seiten
RZ600 Datasheet, Funktion
www.DataSheet4U.com
AVR600: RZ600 HW Manual
Features
Contains the full selection of AT86RF family radio transceivers.
Covers the 2.4GHz ISM band and 700, 800 and 900MHz frequency bands.
In total 3 pair of radio transceivers are available – one pair per radio transceiver.
Two ATUC3A3256 based USB host boards are included
- Based on Atmel® AVR® UC core
- 80 Dhrystone MIPS and Draws Only 40 mA at 66 MHz
- Low, full and high speed USB compliant
- Ideal for PC to RF gateways, packet sniffers and network commissioning tools
On board ID chip for easy IEEE MAC address
Stub antennas for all frequency bands
8-bit
Microcontrollers
Application Note
1 Introduction
The RZ600 kit is an evaluation kit for the Atmel AT86RF family of radio frequency
devices. The family contains the two 2.4GHz device AT86RF230 and AT86RF231.
These are highly acclaimed networking devices within low power personal area
networks. In addition to this the world’s first IEEE 802.15.4 enabled sub gigahertz
radio is provided – the AT86RF212. With the kit you also receive two AVR UC3
based host nodes that can be used to evaluate a point to point network connection.
That being said; the RZ600 radio boards sport an Atmel standardized 10-pin
connector that will enable the RF boards to be connected to any AVR
microcontroller. A wide range of the standard Atmel AVR design tools have the
host end of the standardized 10-pin connector – so as a customer you will be able
to evaluate Atmel radio transceivers in virtually any application segment.
The RZ600 kit enables RF4CE, IEEE 802.15.4, ZigBee® and 6lowPAN network
technologies to run on the full Atmel portfolio of low power AVR microcontrollers.
Figure 1-1. RZ600 HW Overview
Rev. 8293A-AVR-03/10






RZ600 Datasheet, Funktion
Figure 4-1 Radio Frequency Board Overview
SMA con
www.DataSheet4U.com
GND
Current sens
MISC signal
selector
MISC signal
4.1.1 Connectors
10 pin con
There are two main connectors on the board; one is the female SMA antenna
connector and in the opposite direction of the board is a 10-pin dual row header. See
Table 4-1 for pinout of this header.
6 AVR600
8293A-AVR-03/10

6 Page









RZ600 pdf, datenblatt
www.DataSheet4U.com
4.4 Cables
The antennas should be screwed onto the respective radio frequency board and
gently tightened.
There are two different cable types available in the RZ600 kit
Squid Cable:
Single Wire:
5 Connecting Radio Frequency Board to a Custom Board
The radio frequency boards found as part of this kit can be used stand alone as well
as in conjunction with the processor board. Table 4-1 shows the pinout of the
standardized 10-pin bus that is defined between the two unit. However, it is possible
to add the radio frequency board to any routing as long as the required signals are
available. This is possible due to the radio frequency board being able to be mounted
on the squid cable included in this kit. With this squid cable it is possible to route all
10 signals down onto a custom hardware. The reminder of this chapter shows a few
examples on how to wire these signals.
5.1 Default Supported Kits
Besides from being used on the processor boards the radio frequency board can be
attached to wide range of Atmel evaluation and starter kits. The following kits are
supported directly. If you do not find your preferred kit here, please take a look at
section 5.2.
Table 5-1. Plug and Play Kits
Kit Name
Comment
STK600
- Any ATxmega device
Any of the digital ports can be used.
- ATmega164/324/644/1284P
STK500
- ATmega164/324/644/1284P
XPLAIN
EVK1104
EVK1105
Any of the digital ports can be used.
Squid Cable.
Squid Cable.
5.2 Squid Cable
There are two squid cables (10pin male header to single wires) included in the kit.
The intended use of this special cable assembly is to plug the radio frequency board
onto it, and connect the ten single wires to any hardware platform that does not have
the standard auxiliary connector available.
Table 5-2. Squid Cable Pinout
PIN PIN
Pin 1 (Brown): Reset Pin 2 (Red): Miscellaneous
12 AVR600
8293A-AVR-03/10

12 Page





SeitenGesamt 18 Seiten
PDF Download[ RZ600 Schematic.PDF ]

Link teilen




Besondere Datenblatt

TeilenummerBeschreibungHersteller
RZ6008-bit AVR MicrocontrollersATMEL Corporation
ATMEL Corporation

TeilenummerBeschreibungHersteller
CD40175BC

Hex D-Type Flip-Flop / Quad D-Type Flip-Flop.

Fairchild Semiconductor
Fairchild Semiconductor
KTD1146

EPITAXIAL PLANAR NPN TRANSISTOR.

KEC
KEC


www.Datenblatt-PDF.com       |      2020       |      Kontakt     |      Suche