|
|
PDF MB95F128MB Data sheet ( Hoja de datos )
| Número de pieza | MB95F128MB | |
| Descripción | 8-bit Microcontrollers | |
| Fabricantes | Fujitsu Media Devices | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de MB95F128MB (archivo pdf) en la parte inferior de esta página. Total 30 Páginas | ||
|
No Preview Available !
FUJITSU MICROELECTRONICS
DATA SHEET
DS07-12610-3Ea
8-bit Microcontrollers
CMOS
F2MC-8FX MB95120MB series
MB95128MB/F124MB/F124NB/F124JB/F126MB/F126NB/
www.DataSheet4U.com
MB95F126JB/F128MB/F128NB/F128JB/FV100D-103
■ DESCRIPTION
The MB95120MB series is general-purpose, single-chip microcontrollers. In addition to a compact instruction set,
the microcontrollers contain a variety of peripheral functions.
Note : F2MC is the abbreviation of FUJITSU Flexible Microcontroller.
■ FEATURE
• F2MC-8FX CPU core
Instruction set optimized for controllers
• Multiplication and division instructions
• 16-bit arithmetic operations
• Bit test branch instruction
• Bit manipulation instructions etc.
• Clock
• Main clock
• Main PLL clock
• Sub clock
• Sub PLL clock
• Timer
• 8/16-bit compound timer × 2 channels
• Can be used to interval timer, PWC timer, PWM timer and input capture.
• 16-bit reload timer × 1 channel
• 8/16-bit PPG × 2 channels
• 16-bit PPG × 2 channels
(Continued)
Be sure to refer to the “Check Sheet” for the latest cautions on development.
“Check Sheet” is seen at the following support page
URL : http://edevice.fujitsu.com/micom/en-support/
“Check Sheet” lists the minimal requirement items to be checked to prevent problems beforehand in system
development.
Copyright©2006-2008 FUJITSU MICROELECTRONICS LIMITED All rights reserved
2007.8
1 page  
MB95120MB Series
(Continued)
Part number
Parameter
MB95128MB
MB95F124MB
MB95F126MB
MB95F128MB
MB95F124NB
MB95F126NB
MB95F128NB
MB95F124JB
MB95F126JB
MB95F128JB
LCD controller
(LCDC)
www.DataSheet4U.com
COM output
: 4 (Max)
SEG output
: 40 (Max)
LCD drive power supply (bias) pin
: 4 (Max)
40 SEG × 4 COM
: 160 pixels can be displayed.
Duty LCD mode
Operable in LCD standby mode
With blinking function
Built-in division resistance for LCD drive
16-bit reload timer
(1 channel)
Two clock modes and two counter operating modes can be selected.
Square waveform output
Count clock : 7 internal clocks and external clock can be selected.
Counter operating mode : reload mode or one-shot mode can be selected.
8/16-bit compound
timer (2 channels)
Each channel of the timer can be used as “8-bit timer × 2 channels” or “16-bit timer ×
1 channel”.
Built-in timer function, PWC function, PWM function, capture function and square
waveform output
Count clock : 7 internal clocks and external clock can be selected.
16-bit PPG
(2 channels)
8/16-bit PPG
(2 channels)
PWM mode or one-shot mode can be selected.
Counter operating clock : Eight selectable clock sources
Support for external trigger start
Each channel of the PPG can be used as “8-bit PPG × 2 channels” or “16-bit PPG ×
1 channel”.
Counter operating clock : Eight selectable clock sources
Watch counter
Count clock : Four selectable clock sources (125 ms, 250 ms, 500 ms, or 1 s)
Counter value can be set from 0 to 63 (Capable of counting for 1 minute when selecting
clock source 1 second and setting counter value to 60) .
Watch prescaler
(1 channel)
4 selectable interval times (125 ms, 250 ms, 500 ms, or 1 s)
External interrupt Interrupt by edge detection (rising, falling, or both edges can be selected.)
(12 channels)
Can be used to recover from standby modes.
Flash memory
Supports automatic programming, Embedded AlgorithmTM *3
Write/Erase/Erase-Suspend/Resume commands
A flag indicating completion of the algorithm
Number of write/erase cycles (Minimum) : 10000 times
Data retention time : 20 years
Erase can be performed on each block
Block protection with external programming voltage
Dual operation Flash memory
Flash Security Feature for protecting the content of the Flash
Standby mode
Sleep, stop, watch, and timebase timer
*1 : For ROM capacitance and RAM capacitance, refer to “■ MEMORY LINEUP”.
*2 : For details of option, refer to “■ MASK OPTION”.
*3 : Embedded Algorithm is a trade mark of Advanced Micro Devices Inc.
Note : Part number of evaluation product in MB95120MB series is MB95FV100D-103. When using it, the MCU
board (MB2146-303A) is required.
5
5 Page 
MB95120MB Series
Pin no.
LQFP *1
QFP *2
26
27
28
29
30
www.DataSheet4U.com31
32
33
34
35
36
37
38
29
30
31
32
33
34
35
36
37
38
39
40
41
39 42
40 43
41 44
42 45
43 46
44 47
45 48
46 49
47 50
48 51
49 52
50 53
51 54
Pin name
AVSS
P30/AN00
P31/AN01
P32/AN02
P33/AN03
P34/AN04
P35/AN05
P36/AN06
P37/AN07
P40/AN08
P41/AN09
P42/AN10
P43/AN11
P53/TRG1
P70/TO0
P71/TI0
P67/SEG39/
SIN
P66/SEG38/
SOT
P65/SEG37/
SCK
P64/SEG36/
EC1
P63/SEG35/
TO11
P62/SEG34/
TO10
RST
X0A
X1A
VSS
I/O
circuit
type*3
⎯
Function
A/D converter power supply pin (GND)
J
General-purpose I/O port
The pins are shared with A/D converter analog input.
J
General-purpose I/O port
The pins are shared with A/D converter analog input.
H
General-purpose I/O port
The pin is shared with 16-bit PPG ch.1 trigger input.
General-purpose I/O port
The pin is shared with 16-bit reload timer ch.0 output.
H
General-purpose I/O port
The pin is shared with 16-bit reload timer ch.0 input.
General-purpose I/O port
N The pin is shared with LCDC SEG output (SEG39) and LIN-
UART data input (SIN) .
General-purpose I/O port
The pin is shared with LCDC SEG output (SEG38) and LIN-
UART data output (SOT) .
General-purpose I/O port
The pin is shared with LCDC SEG output (SEG37) and LIN-
UART clock I/O (SCK) .
M General-purpose I/O port
The pin is shared with LCDC SEG output (SEG36) and
8/16-bit compound timer ch.1 clock input (EC1) .
General-purpose I/O port
The pins are shared with LCDC SEG output (SEG34,
SEG35) and 8/16-bit compound timer ch.1 output (TO10,
TO11) .
B' Reset pin
A Sub clock oscillation pin (32 kHz)
⎯ Power supply pin (GND)
(Continued)
11
11 Page | ||
| Páginas | Total 30 Páginas | |
| PDF Descargar | [ Datasheet MB95F128MB.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| MB95F128MB | 8-bit Microcontrollers | Fujitsu Media Devices |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |