|
|
PDF SPS-440-1 Data sheet ( Hoja de datos )
| Número de pieza | SPS-440-1 | |
| Descripción | Receiver Pre-Amp Module | |
| Fabricantes | Sanyo | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de SPS-440-1 (archivo pdf) en la parte inferior de esta página. Total 5 Páginas | ||
|
No Preview Available !
Orwdwerwin.Dg antuamSbheere:t4EUN.Nco6m047
SPS-440 Series
SPS-440 Series
Receiver Pre-amp Module for
Infrared Remote Control
Features
• This is an unified module consisting of a PIN photodiode and receiver pre-amp IC.
It is a compact type, not necessary to mount outer part, and provides low voltage and low power consumption.
• It also puts a measure to inverter fluorescent lamp with a high frequency trap circuit for band-pass filter.
• It has leads at the both sides, so it is easy to put it on PCB.
Absolute Maximum Ratings at Ta=25°C (as per JIS C 7032)
Parameter
Line Voltage
Power Dissipation
Operating Temperature
Storage Temperature
Soldering Temperature
Symbol
VCC
PD
Topr
Tstg
Tsol
Rating
0 to +6.3
100
--10 to +60
--20 to +70
+260 *1
Unit
V
mW
°C
°C
°C
Recommended Operating Condition at Ta=25°C
Parameter
Symbol
Opr. Condition
Unit
Line Voltage
VCC
+4.7 to +5.3
V
We recommend the signal format with leader code (for example ; NEC format or Home Electrical Appliances Society
format in Japan) for the remote control transmitter.
Electrical / Optical Characteristics at Ta=25°C, VCC=5.0V D.C.
Parameter
Symbol
Condition
Min. Typ. Max. Unit
Consumption Current
ICC Non-signal input
-- 1.4 2.2 mA
*2 On axis
7.5 10.0
--
m
*2 form device
Controlling Distance
L Cone with its limit
inclined at 30 deg to axis
5.0
--
--
m
Cone with its limit
inclined at 40 deg to axis
3.0
--
--
m
Low-level Output Voltage
VL *2 At the point of 30cm on axis
--
-- 0.5 V
High-level Output Voltage
VH *2 At the point of 30cm on axis 4.5
--
--
V
*2 Specified by TWL time
Low-level Pulse Width
TWL interval of output at the
300 610 900
µs
point of 30cm and 7.5m on axis
*2 Specified by TWH time
High-level Pulse Width
TWH
interval of output at the
300 590 900
µs
point of 30cm and 7.5m on axis
Carrier Wave Frequency
fo
--
-- *3 -- kHz
*1 Soldering time : with in 3sec and clearance of 1mm from lead stopper.
*2 As shown in Fig.1, burst wave shall be transmitted by our transmitter in item 7. Detector face illuminance : Ee < 10 lx
*3 Carrier wave frequency (fo) differs every a type. Refer to the following list.
SANYO Electric Co.,Ltd. Semiconductor Company
TOKYO OFFICE Tokyo Bldg., 1-10, 1 Chome, Ueno, Taito-ku, TOKYO, 110-8534 JAPAN
D2099 GI, (MI) No.6047 1/5
1 page  
www.DataSheet4U.com
SPS-440 Series
CAUTION
1. No products described or contained herein are intended for use in surgical implants, life-support systems,
aerospace equipment, nuclear power control systems, vehicles, disaster / crime-prevention equipment or
the like, and the failure of which may directly or indirectly cause injury, death or property loss.
2. Anyone purchasing any products described or contained herein for an above-mentioned use shall:
1) Accept full responsibility and indemnify and defend SANYO ELECTRIC CO.,LTD., it’s affiliates,
subsidiaries and distributors or any of their officers and employees, jointly and severally, against any
and all claims and litigation and all damages, costs and expenses associated with such use.
2) Not impose any responsibility for any fault or negligence which may be cited in any such claim or
litigation on SANYO ELECTRIC CO., LTD., it’s affiliates, subsidiaries and distributors or any of
their officers and employees jointly or severally.
3. Information (including circuit diagrams and circuit parameters) disclosed herein is for example only; it is not
guaranteed for mass production, SANYO believes the information disclosed herein is accurate and reliable,
but no guarantees are made or implied regarding it’s use or any infringements of intellectual property rights
or other rights of third parties.
Precautionary instructions in handling gallium arsenic products
Special precautions must be taken in handling this product because it contains, gallium arsenic, which is
designated as a toxic substance by law. Be sure to adhere strictly to all applicable laws and regulations
enacted for this substance, particularly when it comes to disposal.
Manufactured by ; Tottori SANYO Electric Co., Ltd.
LED Division
5-318, Tachikawa-cho, Tottori City, 680-8634 Japan
TEL: +81-857-21-2137 FAX: +81-857-21-2161
PS No.6047 5/5
5 Page | ||
| Páginas | Total 5 Páginas | |
| PDF Descargar | [ Datasheet SPS-440-1.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| SPS-440-1 | Receiver Pre-Amp Module | Sanyo |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |