DataSheet.es    


PDF GS-R24P Data sheet ( Hoja de datos )

Número de pieza GS-R24P
Descripción STEP-DOWN SWITCHING REGULATOR FAMILY
Fabricantes ST Microelectronics 
Logotipo ST Microelectronics Logotipo



Hay una vista previa y un enlace de descarga de GS-R24P (archivo pdf) en la parte inferior de esta página.


Total 7 Páginas

No Preview Available ! GS-R24P Hoja de datos, Descripción, Manual

www.DataSheet4U.com
GS-R24P
1.8W TO 8W STEP-DOWN SWITCHING REGULATOR FAMILY
FEATURE
MTBF 1 000 000 hours (Tamb=25)C)
1.5A max output current
35V max input voltage
1.5V max drop-out voltage
Remote logic inhibit/enable
Not-latching overload and short circuit
protection
Thermal shutdown
Fixed or adjustable output
No heatsink required
PRELIMINARY
DESCRIPTION
The GS-R24P series is a family of high efficiency
step down switching voltage regulator, designed to
replace linear regulators.
Based on STM L5973 device, this non isolated family
of regulators are suitable for the full spectrum of ap-
plications including telecom, industry, computer and
distributed power system applications having a wide-
ly ranging input voltage.
Packing type: V = vertical PTH
Packing type: H = horizontal PTH
-------------------S = horizontal SMD
June 2004
This is preliminary information on a new product now in development. Details are subject to change without notice.
1/7

1 page




GS-R24P pdf
USER NOTES
Input Voltage
The recommended operating maximum DC Input Voltage is 35V inclusive of ripple voltage.
GS-R24P
Inhibit function
The inhibit feature allows to put in stand-by mode the device.
With INH pin 4 higher than 2.2V the device is disabled and the power consumption is reduced to less than
150µA for Vi = 35V.
With INH pin lower than 0.8V, the device is enabled.
If the INH pin is left floating, an internal pull up ensures that the voltage at the pin reaches the inhibit threshold
and the device is disabled.
The pin is also Vi compatible.
Current protection
The device has two current limit protections, pulse by pulse and frequency fold back.
The current is sensed through a resistor and if reaches the threshold, the on time is reduced and consequently
the output voltage too.
Since the minimum switch ON time (necessary to avoid false overcurrent signal) is not enough to obtain a suf-
ficiently low duty cycle at 250 Hz, the output current, in strong overcurrent or short circuit conditions, could in-
crease again.
For this reason the switching frequency is also reduced, so keeping the inductor current under its maximum
threshold.
The frequency depends on the feedback voltage.
As the feedback voltage decreases (due to the reduced duty cycle), the switching frequency decrease too.
Thermal shutdown
The shutdown block generates a signal that turns off the power stage if the temperature of the internal chip goes
higher than a fixed internal threshold (150 ºC).
The sensing element of the chip is very close to the PDMOS area, so ensuring an accurate and fast temperature
detection.
An hysteresis of approximately 20ºC avoids that the devices turns on and off continuously.
Thermal Characteristics
Output voltage programming (GS-R24H(S)0001.5 only)
The GS-R24P output voltage is 5.54V ±4%, to reduce this value connect a resistor between pin 6 (FB) and
pin 5 (Vout-c).
The resistor must be located very close to the proper pins, to minimize the injected noise (see figure 1).
The resistor value is calculated using the following formula:
Rv=[(Vout-1.235)*11.3]/(5.54-Vout) --[kOhm]
Vout can be adjusted between 1.235V (Rv=0 Ohm) and 5.54V (Rv=open)
5/7

5 Page










PáginasTotal 7 Páginas
PDF Descargar[ Datasheet GS-R24P.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
GS-R24FDC/DC Converter ModulesST Microelectronics
ST Microelectronics
GS-R24FPDC/DC Converter ModulesST Microelectronics
ST Microelectronics
GS-R24PSTEP-DOWN SWITCHING REGULATOR FAMILYST Microelectronics
ST Microelectronics

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar