Datenblatt-pdf.com


IS22C040 Schematic ( PDF Datasheet ) - ISSI

Teilenummer IS22C040
Beschreibung 32 to 40 SEC INSTANT VOICE ROM
Hersteller ISSI
Logo ISSI Logo 




Gesamt 11 Seiten
IS22C040 Datasheet, Funktion
www.DataSheet4U.com
IS22C040
IS22C040
32 to 40 SEC INSTANT VOICE ROM
ISISSSII®®
OCTOBER 1998
FEATURES
GENERAL DESCRIPTION
• Voice length at
IS22C040 is a high-quality voice synthesizer with a capacity
– 8 KHz sampling is 32 seconds
of 32 to 40 seconds. A proprietary ADPCM algorithm is
– 6 KHz sampling is 40 seconds
• Silence compression to save memory
• Eight trigger pins, S1 to S8 for 32 sections
• SBT pin play-all or sequential play-all
used. The audio message is stored in a 1024-Kbit on-chip
EPROM.
The IS22C040 eliminates the need of complicated circuitry
in voice playback (Figure 1) but still achieves high voice
quality. Sounds such as human speech, animal sounds,
• 15 ms debounce time suitable for CDS
• IRP interrupt pin stops playback at once
• STP stop pulse generated at end of playback
musical sounds, and even special sound effects can be
synthesized. Devices can be cascaded to achieve longer
voice duration (Figure 3). Two devices can be configured
in parallel (Figure 4) in order to achieve signal mixing
• BUSY signal for CPU control
• Two LEDs flash at 3 Hz interval
• 3.0V to 6V single power supply operation
• Low standby current (<5 µA at 3V)
without an external mixer allowing speeches to be mixed
with background music synthesis from two different chips.
The instant programming nature of the IS22C040 allows a
very short production turnaround time. There are no NRE
charges that are usually required with conventional voice
• Auto-power down
ROMs. Users now can apply a voice synthesis function as
• Built-in oscillator, D/A converter, EPROM
an additional feature to their products even when production
volume is relatively small. It is also ideal for trial or
• ADPCM data compression
engineering prototyping. As a result, the initial investment
www.DataSheet4U.com• Optional pop noise elimination function
is minimal and the risk in the product development phase
• COUT pin drives speaker with a transistor
is reduced.
• Development tools support
• VOUT1 and VOUT2 drives buzzer directly
The IS22C040 provides a wide voltage operating range
from 3.0V to 6.0V. A pair of PWM output pins, VOUT1 and
VOUT2 provide direct drive to a buzzer (Figure 2). Voice
• Sampling rate determined by external resistor
quality from a buzzer is comparable to speaker output and
• Holdable and unholdable triggering option
power consumption is much lower.
• Industrial temperature available
A current output pin, COUT, enables the device to drive a
speaker with a low cost NPN transistor. No complex
filtering or amplifier circuit is needed. An automatic ramp
up/down function eliminates the undesired noise at the
end of playback.
Up to 32 sections are accessible through S1 to S8. The
SBT trigger pin can be programmed to playback all 32
sections or sequentially from section 1 to 32. An interrupt
pin (IRP) and stop pulse (STP) or BUSY signals provide
handshaking with microprocessors or other IS22C040
devices. All trigger pins give 15 ms debounce time and is
ideal for CDS applications as in Figure 6. Two LED drivers
are available, flashing on and off at approximately 3Hz
intervals (Figure 5). The internal voltage compensation
oscillator requires only one external resistor. Different
sampling frequencies are determined by the external
oscillator resistor value.
ISSI reserves the right to make changes to its products at any time without notice in order to improve design and supply the best possible product. We assume no responsibility for any errors which
may appear in this publication. © Copyright 1998, Integrated Silicon Solution, Inc.
Integrated Silicon Solution, Inc.
VP009-1C
10/01/98
DataSheet4 U .com
1
www.DataSheet4U.com






IS22C040 Datasheet, Funktion
www.DataSheet4U.com
IS22C040
ISSI®
TIMING DIAGRAM
PULSE TRIGGERED
a. Trigger is shorter than a phrase output
b. Trigger is longer than a phrase output
S1
S2
COUT
STP
LED
Phrase 2
Phrase 1
Phrase 2
Phrase 2
LEVEL TRIGGERED
a. Trigger is shorter than a phrase output
b. Trigger is longer than a phrase output
S1
S2
COUT
Phrase 2
Phrase 1
Phrase 2
Phrase 2
LED www.DataSheet4U.com
SINGLE BUTTON TRIGGER, NON-SEQUENTIAL PLAY-ALL (SBT)
a. Pulse Triggered
SBT
COUT
Phrase 1 Phrase 2
Phrase N
Phrase 1
Phrase N Phrase 1
b. Level Triggered
SBT
COUT
Phrase 1 Phrase 2
Phrase 1
Phrase N Phrase 1
6
DataSheet4 U .com
Integrated Silicon Solution, Inc.
VP009-1C
10/01/98
www.DataSheet4U.com

6 Page







SeitenGesamt 11 Seiten
PDF Download[ IS22C040 Schematic.PDF ]

Link teilen




Besondere Datenblatt

TeilenummerBeschreibungHersteller
IS22C04032 to 40 SEC INSTANT VOICE ROMISSI
ISSI

TeilenummerBeschreibungHersteller
CD40175BC

Hex D-Type Flip-Flop / Quad D-Type Flip-Flop.

Fairchild Semiconductor
Fairchild Semiconductor
KTD1146

EPITAXIAL PLANAR NPN TRANSISTOR.

KEC
KEC


www.Datenblatt-PDF.com       |      2020       |      Kontakt     |      Suche