|
|
PDF LT1780 Data sheet ( Hoja de datos )
| Número de pieza | LT1780 | |
| Descripción | Low Power 5V RS232 Dual Driver/Receiver with 15kV ESD Protection | |
| Fabricantes | Linear Technology | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de LT1780 (archivo pdf) en la parte inferior de esta página. Total 12 Páginas | ||
|
No Preview Available !
FEATURES
s 10mA Max Supply Current
s ESD Protection to IEC 1000-4-2 Level 4
±15kV Air Gap, ±8kV Contact
s Uses Small Capacitors: 0.1µF
s 120kBaud Operation for RL = 3k, CL = 2500pF
s 250kBaud Operation for RL = 3k, CL = 1000pF
s Outputs Withstand ±30V Without Damage
s CMOS Comparable Low Power: 40mW
s Operates from a Single 5V Supply
s Rugged Bipolar Design
s Outputs Assume a High Impedance State When Off
or Powered Down
s Meets All RS232 Specifications
s Available With or Without Shutdown
s Absolutely No Latch-up
APPLICATI S
s Portable Computers
s Battery-Powered Systems
s Power Supply Generator
s Terminals
s Modems
TYPICAL APPLICATI
0.1µF
2
4
17
3
0.1µF
LOGIC
INPUTS
LOGIC
OUTPUTS
ON/OFF
5
6
12
11
13
10
18
LT1780
7
15
8
14
5k
9
5k 16
5V INPUT
0.1µF
V+ OUT
0.1µF
V – OUT
RS232 OUTPUT
RS232 OUTPUT
RS232 INPUT
RS232 INPUT
1780/81 • TA01
LT1780/LT1781
Low Power 5V RS232
Dual Driver/Receiver with
±15kV ESD Protection
DESCRIPTIO
The LT®1780/LT1781 are dual RS232 driver/receiver pairs
with integral charge pump to generate RS232 voltage
levels from a single 5V supply. Using only 0.1µF external
capacitors, these circuits consume only 40mW of power,
and can operate to 120kbaud even while driving heavy
capacitive loads. New ESD structures on the chip allow the
LT1780/LT1781 to survive ±15kV air gap and ±8kV con-
tact ESD tests per IEC 1000-4-2, eliminating the need for
costly TransZorbs® on the RS232 line pins. The LT1780/
LT1781 are fully compliant with EIA RS232 standards.
Driver outputs are protected from overload, and can be
shorted to ground or up to ±30V without damage. During
SHUTDOWN or power-off conditions, driver and receiver
outputs are in a high impedance state, allowing line
sharing.
The LT1780/LT1781 are direct upgrades to the LT1180A/
LT1181A, LT1280A/LT1281A and LT1381 for applications
which require the utmost ESD protection.
The LT1781 is available in 16-pin DIP,SO and SW pack-
ages. The LT1780 is supplied in 18-pin DIP and SW
packages for applications which require SHUTDOWN.
, LTC and LT are registered trademarks of Linear Technology Corporation.
TransZorb is a registered trademark of General Instruments, GSI.
DRIVER
OUTPUT
RL = 3k
CL = 2500pF
RECEIVER
RCOL U=T5P0UpTF
INPUT
Output Waveforms
1780/81 • TA02
1
1 page  
TYPICAL PERFOR A CE CHARACTERISTICS
LT1780/LT1781
Driver Leakage in Shutdown
100
10
VOUT = 30V
1 VOUT = –30V
0.1
–55 –25
0 25 50 75
TEMPERATURE (°C)
100 125
1780 • G08
Receiver Short-Circuit Current
50
40
RX ISC–
30
RX ISC+
20
10
0
–55 –25
0 25 50 75
TEMPERATURE (°C)
100 125
1780 • G10
DRIVER 1
OUTPUT
Shutdown to Driver Outputs
10V
5V
GND
GND
DRIVER 2 – 5V
OUTPUT
– 10V
ON/OFF PIN
1780 • G12
Driver Short-Circuit Current
30
25
ISC+
20
15
ISC –
10
5
0
–55 –25
0 25 50 75
TEMPERATURE (°C)
100 125
1780 • G09
Slew Rate vs Load Capacitance
16
14
12
10
8
+SLEW
6
–SLEW
4
2
0
0 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 4.5 5.0
LOAD CAPACITANCE (nF)
1780 • G11
Driver Output Waveforms
DRIVER OUTPUT
RL = 3k
CL = 2500pF
DRIVER OUTPUT
RL = 3k
INPUT
1780 • G13
5
5 Page 
LT1780/LT1781
U
PACKAGE DESCRIPTIO Dimensions in inches (millimeters) unless otherwise noted.
S Package
16-Lead Plastic Small Outline (Narrow 0.150)
(LTC DWG # 05-08-1610)
0.386 – 0.394*
(9.804 – 10.008)
16 15 14 13 12 11 10 9
0.228 – 0.244
(5.791 – 6.197)
0.150 – 0.157**
(3.810 – 3.988)
0.010
(0.254
–
–
0.020
0.508)
×
45°
0.008 – 0.010
(0.203 – 0.254)
0° – 8° TYP
1 2 34 5 6 7 8
0.053 – 0.069
(1.346 – 1.752)
0.004 – 0.010
(0.101 – 0.254)
0.016 – 0.050
0.406 – 1.270
*DIMENSION DOES NOT INCLUDE MOLD FLASH. MOLD FLASH
SHALL NOT EXCEED 0.006" (0.152mm) PER SIDE
**DIMENSION DOES NOT INCLUDE INTERLEAD FLASH. INTERLEAD
FLASH SHALL NOT EXCEED 0.010" (0.254mm) PER SIDE
0.014 – 0.019
(0.355 – 0.483)
0.050
(1.270)
TYP
S16 0695
Information furnished by Linear Technology Corporation is believed to be accurate and reliable.
However, no responsibility is assumed for its use. Linear Technology Corporation makes no represen-
tation that the interconnection of its circuits as described herein will not infringe on existing patent rights.
11
11 Page | ||
| Páginas | Total 12 Páginas | |
| PDF Descargar | [ Datasheet LT1780.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| LT1780 | Low Power 5V RS232 Dual Driver/Receiver with 15kV ESD Protection | Linear Technology |
| LT1781 | Low Power 5V RS232 Dual Driver/Receiver with 15kV ESD Protection | Linear Technology |
| LT1782 | Micropower/ Over-The-Top SOT-23/ Rail-to-Rail Input and Output Op Amp | Linear Technology |
| LT1783 | 1.25MHz/ Over-The-Top Micropower/ Rail-to-Rail Input and Output Op Amp in SOT-23 | Linear Technology |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |