NS486SXL Datasheet PDF - National
| Part Number | NS486SXL | |
| Description | Optimized 32-Bit 486-Class Controller with On-Chip Peripherals for Embedded Systems | |
| Manufacturers | National | |
| Logo |  |
|
|
There is a preview and NS486SXL download ( pdf file ) link at the bottom of this page. Total 26 Pages | ||
Preview 1 page No Preview Available !
ADVANCE INFORMATION
December 1997
NS486™SXL
Optimized 32-Bit 486-Class Controller with On-Chip
Peripherals for Embedded Systems
General Description
The NS486SXL is a highly integrated embedded system
controller incorporating an Intel486™-class 32-bit processor
along with all of the necessary System Service Elements,
implementing a true “system on a chip.” It is ideally suited for
a wide variety of applications running in a segmented
protect-mode environment. The NS486SXL is the second
member of the NS486 family.
Features
n 100% compatible with VxWorks™, VRTX™, QNX™
Neutrino, pSOS +®, and other popular real-time
executives and operating system kernels
n Intel486 instruction set compatible (protected mode only)
with optimized performance
n Operation at 25 MHz with 5V supply
n Low cost 132-pin PQFP package
n Industry standard interrupt controller, timers, and real
time clock
n Protected WATCHDOG™ timer
n Optimized DRAM Controller (supports two banks, up to
8 Mbytes each)
n Up to nine versatile, programmable chip selects
n Up to eight external interrupts directly supported, and
additional interrupt expansion through an external PIC
interface
n Glueless interface to ISA-type peripherals
n Arbitration support for auxiliary processor
n Support for External Bus Masters, allowing them to
access DRAM and on-chip Peripherals
n MICROWIRE™/Access.bus synchronous serial
interfaces
n UART with IrDA v1.0 (Infrared Data Association) port
n Reconfigurable I/O: Up to 28 I/O pins can be used as
general purpose bidirectional I/O lines
n Flexible, programmable, multilevel power saving modes
maximize power savings
n Programming model compatible with the NS486SXF
where possible
Block Diagram NS486SXL Single-Chip Embedded Controller
MICROWIRE™, NS486™ and WATCHDOG™ are trademarks of National Semiconductor Corporation.
TRI-STATE® is a registered trademark of National Semiconductor Corporation.
Intel486™ is a trademaek of Intel Corporation.
pSOS +™ is a trademark of Integrated Systems, Inc.
VRTX™ is a registered trademark of Microtec Research, Inc.
PowerPack® is a registered trademark of Microtek International.
QNX™ is a registered trademark of QNX Software Systems, Inc.
VxWorks™ is a registered trademark of Wind River Systems, Inc.
© 1998 National Semiconductor Corporation DS100121
DS100121-1
www.national.com
|
| |
 
1.0 System Overview (Continued)
1.3.6 Power Management Features
The NS486SXL power management structure includes a
number of power saving mechanisms that can be combined
to achieve comprehensive power savings under a variety of
system conditions. First of all, the core processor power con-
sumption can be controlled by varying the processor/system
clock frequency. The internal CPU clock can be divided by 4,
8, 16, 32 or 64. In addition, in idle mode, the internal proces-
sor clock will be disabled. Finally, if an external crystal oscil-
lator circuit is being used, it can be disabled. For maximum
power savings, all internal clocks can be disabled (except for
the real-time clock oscillator).
The clocks of the on-board peripherals can be individually or
globally controlled. By setting bits in the power management
control registers, the internal clocks to the three-wire inter-
face, the timer, the DRAM controller, and the UART can be
disabled.
In addition to these internal clocks, the external SYSCLK can
be disabled via a bit in the power management control regis-
ters.
Using various combinations of these power saving controls
with the NS486SXL controller will result in excellent pro-
grammable power management for any application.
1.4 NS486SXL SYSTEM BUS
The NS486SXL system bus provides the interface to off-chip
peripherals and memory. It offers an ISA compatible inter-
face and is therefore capable of directly interfacing to many
ISA peripheral control devices. The interface is accom-
plished through the Bus Interface Unit (BIU). The BIU gener-
ates all of the access signals for both internal and external
peripherals and memory. Depending upon whether the ac-
cess is to internal peripherals, external peripherals or exter-
nal memory, the BIU generates the timing and control sig-
nals to access those resources. The BIU is designed to
support a glueless interface to many ISA-type peripherals.
For debug purposes, the NS486SXL can be set to generate
external bus cycles at the same time as an internal periph-
eral access takes place. This gives logic analyzers or other
debug tools the ability to track and capture internal periph-
eral accesses.
FIGURE 2. NS486SXL Internal Busses
DS100121-3
Access to internal peripherals is accomplished in three CPU
T-states (clock cycles). The fastest access to off-chip I/O is
also three T-states. When accessing off-chip memory and
I/O, wait state generation is accomplished through a combi-
nation of NS486SXL chip select logic and off-chip peripheral
feedback signals.
The ISA-like bus on the NS486SXL also supports External
Bus Masters. This feature allows external processors or I/O
Peripherals (and customer proprietary ASICs) with built-in
DMA controllers to read and write System DRAM supported
by the ’SXL DRAM Controller. External Masters can also ac-
cess any internal or external peripherals or memory as well.
The external master address must be at TRI-STATE®
(through external address transceivers if necessary) in order
to support external master access to the DRAM.
5 www.national.com
Preview 5 Page |
Part DetailsOn this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for NS486SXL electronic component. |
| Information | Total 26 Pages | |
| Link URL | [ Copy URL to Clipboard ] | |
| Download | [ NS486SXL.PDF Datasheet ] | |
Share Link :
Electronic Components Distributor
|
An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists. |
| SparkFun Electronics | Allied Electronics | DigiKey Electronics | Arrow Electronics |
| Mouser Electronics | Adafruit | Newark | Chip One Stop |
Featured Datasheets
| Part Number | Description | MFRS |
| NS486SXF | The function is NS486 SXF Optimized 32-Bit 486-Class Cntrll w/On-Chip Peri for Embedded Sys (Rev. A). Texas Instruments |  |
| NS486SXF | The function is NS486TMSXF Optimized 32-Bit 486-Class Controller with On-Chip Peripherals for Embedded Systems. National | |
| NS486SXL | The function is Optimized 32-Bit 486-Class Controller with On-Chip Peripherals for Embedded Systems. National | |
Semiconductors commonly used in industry:
1N4148 |
BAW56 |
1N5400 |
NE555 | | ||
Quick jump to:
NS48
1N4
2N2
2SA
2SC
74H
BC
HCF
IRF
KA | ||