Datenblatt-pdf.com


TS634ID Schematic ( PDF Datasheet ) - STMicroelectronics

Teilenummer TS634ID
Beschreibung DUAL WIDE BAND OPERATIONAL AMPLIFIER FOR ADSL LINE INTERFACE
Hersteller STMicroelectronics
Logo STMicroelectronics Logo 




Gesamt 9 Seiten
TS634ID Datasheet, Funktion
TS634
DUAL WIDE BAND OPERATIONAL AMPLIFIER
FOR ADSL LINE INTERFACE
s LOW NOISE : 3.2nV/Hz, 1.5pA/Hz
s HIGH OUTPUT CURRENT : 160mA min.
s VERY LOW HARMONIC AND INTERMODU-
LATION DISTORTION
s HIGH SLEW RATE : 40V/µs
s SPECIFIED FOR 25LOAD
DESCRIPTION
This device is particularly intended for applications
where multiple carriers must be amplified simulta-
neously with very low intermodulation products. It
has been mainly designed to fit with ADSL
chip-set such as ST70134 or ST70135.
The TS634 is a high output current dual operation-
al amplifier, with a large gain-bandwidth product
(130MHz) and capable of driving a 25load at
12V power supply. The TS634 is fitted out with
Power Down function in order to decrease the
consumption.
The TS634 is housed in SO20 batwing plastic
package for a very low thermal resistance.
APPLICATION
s UPSTREAM line driver for Asymmetric Digital
Subscriber Line (ADSL) (NT).
D
SO20 Batwing
(Plastic Micropackage)
ORDER CODE
Part
Number
TS634ID
Temperature
Range
-40, +85°C
Package
DP
D=Small Outline Package (SO) - also available in Tape & Reel (DT)
PIN CONNECTIONS (top view)
SO20 batwing - Top View
Power Down 1 1
Inverting input 1 2
Non-inverting input 1 3
Vcc - 4
Thermal Heat Tabs
connected to -Vcc
Vcc - 5
Vcc - 6
Vcc - 7
Non-Inverting input 2 8
Inverting input 2 9
Power Down 2 10
_
+
+
_
20 Vcc+ 1
19 Output 1
18 Vcc-
17 Vcc -
16 Vcc -
Thermal Heat Tabs
15 Vcc - connected to -Vcc
14 Vcc -
13 GND
12 Output 2
11 Vcc+ 2
March 2003
1/9






TS634ID Datasheet, Funktion
TS634
THE TS634 AS LINE DRIVER ON ADSL LINE
INTERFACE. SINGLE SUPPLY
IMPLEMENTATION WITH PASSIVE OR ACTIVE
IMPEDANCE MATCHING.
THE LINE INTERFACE - ADSL Remote
Terminal (RT):
The Figure1 shows a typical analog line interface
used for ADSL service. On this note, the accent
will be made on the emission path. The TS634 is
used as a dual line driver for the upstream signal.
Figure 1 : Typical ADSL Line Interface
high output
current
ST70135
ST70134
emission LP filter
(analog)
reception
(analog)
upstream
TS634
Line Driver
VGA
impedance
matching
HYBRID
CIRCUIT
twisted-pair
telephone
line
downstream
TS636
Receiver
For the remote terminal it is required to create an
ADSL modem easy to plug in a PC. In such an ap-
plication, the driver should be implemented with a
+12 volts single power supply. This +12V supply is
available on PCI connector of purchase.
The Figure 2 shows a single +12V supply circuit
that uses the TS634 as a remote terminal trans-
mitter in differential mode.
Figure 2 : TS634 as a differential line driver with
a +12V single supply
100n
+ +12V
+12V
1k
_ GND
R2
Vi
47k
1/2 R1
Vcc/2
1/2 R1
Vi 10µ 47k 100n
1k GND
R3
+ +12V
100n
_
GND
12.5 10n
1:2
Vo
25
Hybrid
& 100Ω
Transformer
Vo
12.5
The driver is biased with a mid supply (nominaly
+6V), in order to maintain the DC component of
the signal at +6V. This allows the maximum dy-
namic range between 0 and +12 V. Several op-
tions are possible to provide this bias supply (such
as a virtual ground using an operational amplifier),
such as a two-resistance divider which is the
cheapest solution. A high resistance value is re-
quired to limit the current consumption. On the
other hand, the current must be high enough to
bias the inverting input of the TS634. If we consid-
er this bias current (5µA) as the 1% of the current
through the resistance divider (500µA) to keep a
stable mid supply, two 47kresistances can be
used.
The input provides two high pass filters with a
break frequency of about 1.6kHz which is neces-
sary to remove the DC component of the input sig-
nal. To avoid DC current flowing in the primary of
the transformer, an output capacitor is used. The
this case the load impedance is 25for each driv-
er.
For the ADSL upstream path necessary to avoid
any distortion. In this simple non-inverting amplifi-
cation configuration, it will be easy to implement a
Sallen-Key lowpass filter by using the TS634. For
ADSL over POTS, a maximum frequency of
135kHz is reached. For ADSL over ISDN, the
maximum frequency will be 276kHz.
INCREASING THE LINE LEVEL BY USING AN
ACTIVE IMPEDANCE MATCHING
With passive matching, the output signal ampli-
tude of the driver must be twice the amplitude on
the load. To go beyond this limitation an active
maching impedance can be used. With this tech-
nique it is possible to keep good impedance
matching with an amplitude on the load higher
than the half of the ouput driver amplitude. This
concept is shown in Figure 3 for a differential line.
Figure 3 : TS634 as a differential line driver with
an active impedance matching
100n
Vcc+
1k
Vi
+ Vcc+
_ GND
R2
1/2 R1 R3
Vcc/2
1/2 R1 R5
Vi 10µ 100n
1k
GND
R4
+ Vcc+
100n
_
GND
Rs1
Vo°
Vo°
Rs2
1µ
10n
Vo
RL
1:n
Hybrid
& 100
Transformer
Vo
6/9

6 Page







SeitenGesamt 9 Seiten
PDF Download[ TS634ID Schematic.PDF ]

Link teilen




Besondere Datenblatt

TeilenummerBeschreibungHersteller
TS634IDDUAL WIDE BAND OPERATIONAL AMPLIFIER FOR ADSL LINE INTERFACESTMicroelectronics
STMicroelectronics

TeilenummerBeschreibungHersteller
CD40175BC

Hex D-Type Flip-Flop / Quad D-Type Flip-Flop.

Fairchild Semiconductor
Fairchild Semiconductor
KTD1146

EPITAXIAL PLANAR NPN TRANSISTOR.

KEC
KEC


www.Datenblatt-PDF.com       |      2020       |      Kontakt     |      Suche