Datenblatt-pdf.com


X84641V20 Schematic ( PDF Datasheet ) - Xicor

Teilenummer X84641V20
Beschreibung uPort Saver EEPROM
Hersteller Xicor
Logo Xicor Logo 




Gesamt 18 Seiten
X84641V20 Datasheet, Funktion
APPLICATION NOTE
A V A I LABLE
AN95 • AN103 • AN107
16K/64K/128K
X84161/641/129
µPort Saver EEPROM
MPSEEPROM
FEATURES
• Up to 10MHz data transfer rate
• 25ns Read Access Time
• Direct Interface to Microprocessors and
Microcontrollers
—Eliminates I/O port requirements
—No interface glue logic required
—Eliminates need for parallel to serial converters
• Low Power CMOS
—1.8V–3.6V, 2.5V–5.5V and 5V ±10% Versions
—Standby Current Less than 1µA
—Active Current Less than 1mA
• Byte or Page Write Capable
—32-Byte Page Write Mode
• Typical Nonvolatile Write Cycle Time: 2ms
• High Reliability
—100,000 Endurance Cycles
—Guaranteed Data Retention: 100 Years
DESCRIPTION
The µPort Saver memories need no serial ports or spe-
cial hardware and connect to the processor memory bus.
Replacing bytewide data memory, the µPort Saver uses
bytewide memory control functions, takes a fraction of
the board space and consumes much less power.
Replacing serial memories, the µPort Saver provides all
the serial benefits, such as low cost, low power, low volt-
age, and small package size while releasing I/Os for
more important uses.
The µPort Saver memory outputs data within 25ns of an
active read signal. This is less than the read access time
of most hosts and provides “no-wait-state” operation.
This prevents bottlenecks on the bus. With rates to 10
MHz, the µPort Saver supplies data faster than required
by most host read cycle specifications. This eliminates
the need for software NOPs.
The µPort Saver memories communicate over one line of
the data bus using a sequence of standard bus read and
write operations. This “bit serial” interface allows the
µPort Saver to work well in 8-bit, 16 bit, 32-bit, and 64-bit
systems.
A Write Protect (WP) pin prevents inadvertent writes to
the memory.
Xicor EEPROMs are designed and tested for applica-
tions requiring extended endurance. Inherent data reten-
tion is greater than 100 years.
BLOCK DIAGRAM
System Connection
Ports
Saved
µP
µC
DSP
ASIC
RISC
P0/CS
P1/CLK
P2/DI
P3/DO
A15
A0
D7
D0
OE
WE
©Xicor, Inc. 1994, 1997Patents Pending
7008-1.2 8/26/97 T2/C0/D0 SH
Internal Block Diagram
MPS
WP H.V. GENERATION
TIMING & CONTROL
CE
COMMAND
I/O DECODE
OE
AND
CONTROL
LOGIC
WE
X
DEC
EEPROM
ARRAY
16K x 8
8K x 8
2K x 8
Y DECODE
DATA REGISTER
7008 FRM F02.1
1 Characteristics subject to change without notice






X84641V20 Datasheet, Funktion
X84161/641/129
ABSOLUTE MAXIMUM RATINGS*
Temperature under Bias ...................... –65°C to +135°C
Storage Temperature ........................... –65°C to +150°C
Terminal Voltage with
Respect to VSS .......................................–1V to +7V
DC Output Current................................................... 5mA
Lead Temperature (Soldering, 10 seconds)..........300°C
RECOMMENDED OPERATING CONDITIONS
Temperature
Min.
Commercial
0°C
Industrial
–40°C
Military†
–55°C
Notes: Contact factory for Military availability
Max.
+70°C
+85°C
+125°C
7008 FRM T02
*COMMENT
Stresses above those listed under “Absolute Maximum
Ratings” may cause permanent damage to the device.
This is a stress rating only and the functional operation
of the device at these or any other conditions above
those indicated in the operational sections of this speci-
fication is not implied. Exposure to absolute maximum
rating conditions for extended periods may affect device
reliability.
Supply Voltage
X84161/641/129
X84161/641/129 – 2.5
X84161/641/129 – 1.8
Limits
5V ±10%
2.5V to 5.5V
1.8V to 3.6V
7008 FRM T03
D.C. OPERATING CHARACTERISTICS (VCC = 5V ±10%)
(Over the recommended operating conditions, unless otherwise specified.)
Symbol
Parameter
Limits
Min.
Max.
Units
ICC1
VCC Supply Current (Read)
1 mA
ICC2
ISB1
ILI
ILO
VlL (1)
VIH (1)
VOL
VOH
VCC Supply Current (Write)
VCC Standby Current
Input Leakage Current
Output Leakage Current
Input LOW Voltage
Input HIGH Voltage
Output LOW Voltage
Output HIGH Voltage
2
–0.5
VCC x 0.7
VCC – 0.8
1
10
10
VCC x 0.3
VCC + 0.5
0.4
Notes: (1) VIL Min. and VIH Max. are for reference only and are not tested.
mA
µA
µA
µA
V
V
V
V
Test Conditions
OE = VIL, WE = VIH,
I/O = Open, CE clocking @ 10MHz
ICC During Nonvolatile Write Cycle
All Inputs at CMOS Levels
CE = VCC, Other Inputs = VCC or VSS
VIN = VSS to VCC
VOUT = VSS to VCC
IOL = 2.1mA
IOH = –1mA
7008 FRM T04.2
6

6 Page









X84641V20 pdf, datenblatt
X84161/641/129
8-LEAD PLASTIC DUAL IN-LINE PACKAGE TYPE P
0.430 (10.92)
0.360 (9.14)
PIN 1 INDEX
PIN 1
0.300
(7.62) REF.
0.260 (6.60)
0.240 (6.10)
0.060 (1.52)
0.020 (0.51)
HALF SHOULDER WIDTH ON
ALL END PINS OPTIONAL
SEATING
PLANE
0.150 (3.81)
0.125 (3.18)
0.110 (2.79)
0.090 (2.29)
0.145 (3.68)
0.128 (3.25)
0.025 (0.64)
0.015 (0.38)
0.065 (1.65)
0.045 (1.14)
0.020 (0.51)
0.016 (0.41)
.073 (1.84)
MAX.
TYP .0.010 (0.25)
0.325 (8.25)
0.300 (7.62)
0°
15°
NOTE:
1. ALL DIMENSIONS IN INCHES (IN PARENTHESES IN MILLIMETERS)
2. PACKAGE DIMENSIONS EXCLUDE MOLDING FLASH
12

12 Page





SeitenGesamt 18 Seiten
PDF Download[ X84641V20 Schematic.PDF ]

Link teilen




Besondere Datenblatt

TeilenummerBeschreibungHersteller
X84641V20uPort Saver EEPROMXicor
Xicor
X84641V20-1.8uPort Saver EEPROMXicor
Xicor
X84641V20-2.5uPort Saver EEPROMXicor
Xicor
X84641V20IuPort Saver EEPROMXicor
Xicor
X84641V20I-1.8uPort Saver EEPROMXicor
Xicor

TeilenummerBeschreibungHersteller
CD40175BC

Hex D-Type Flip-Flop / Quad D-Type Flip-Flop.

Fairchild Semiconductor
Fairchild Semiconductor
KTD1146

EPITAXIAL PLANAR NPN TRANSISTOR.

KEC
KEC


www.Datenblatt-PDF.com       |      2020       |      Kontakt     |      Suche