|
|
Teilenummer | 3625 |
|
Beschreibung | POWERHALL SENSOR/DRIVERS FOR BRUSHLESS DC MOTORS | |
Hersteller | Allegro MicroSystems | |
Logo | ||
Gesamt 8 Seiten 3625 AND
3626
CONTACT FACTORY
for availability
and latest information
ABSOLUTE MAXIMUM RATINGS
Supply Voltage, VCC . . . . . . . . . . See Table
Output Current, IO . . . . . . . . . . . . See Table
PWM Current Control Voltage,
VADJ . . . . . . . . . . . . . See Applications
Magnetic Flux Density, B . . . . . . Unlimited
Package Power Dissipation,
PD . . . . . . . . . . . . . . . . . . . . See Graph
Operating Temperature Range,
TA . . . . . . . . . . . . . . . . . -20°C to +85°C
Storage Temperature Range,
TS . . . . . . . . . . . . . . . . -65°C to +150°C
VCC(MAX)
IO(CONT)
IO(PEAK)
UDN3625M
14 V
1.0 A
1.6 A
UDN3626M
26 V
0.45 A
0.75 A
Output current rating will be limited by
ambient temperature, supply voltage, and
duty cycle. Under any set of conditions, do
not exceed a junction temperature of
+150°C.
POWERHALL® SENSOR/DRIVERS
FOR BRUSHLESS DC MOTORS
Requiring a minimum of external components, the UDN3625M
and UDN3626M are monolithic ICs that provide single-chip control
and direct drive solutions for many small, single-phase, unipolar
brushless dc motor applications. Integrated into the ICs are a high-
sensitivity Hall-effect sensor, control and commutating logic, a stable
voltage regulator, extensive self and system protective functions, and
two high-current saturated npn outputs. Both ICs include thermal
shutdown, output over-current limiting, and output transient protection/
flyback diodes. The UDN3625M is nominally for 12 V motor applica-
tions while the UDN3626M is better suited to 24 V motors.
Output over-current limiting (relating to startup surge or a locked
rotor condition) and short-circuit protection are provided by an internal
current-sense resistor. The maximum (default) output load current is
typically 1.3 A for the UDN3625M or 600 mA for the UDN3626M,
but may be decreased by user selection of an external low-wattage
resistor.
A separate low-level output provides tachometer capability for
motor speed control or sensing a locked rotor condition. With appro-
priate external logic, pulse-width modulated (PWM) speed control can
be accomplished at the output current adjust pin.
These sensor/drivers are supplied in an 8-pin mini-DlP plastic
package with a copper leadframe for increased package power
handling capability.
FEATURES
s 900 mA /12 V or 400 mA /24 V Operation
s Speed-Control (PWM) Capability
s Locked-Rotor Indication
s Minimum External Components
s Over-Current Protected
s Thermal Protection
s Enhanced Reliability
s Reduced Cost
Always order by complete part number, e.g., UDN3625M .
See Maximum Ratings at left.
3625 AND 3626
POWERHALL®
SENSOR/DRIVERS FOR
BRUSHLESS DC MOTORS
The external overcurrent adjust and the thermal shutdown are commoned
at the PWM/lO ADJ pin and tieing it to VCC will disable the thermal shut-
down. PWM current/speed control can be performed at the PWM/lO ADJ pin
from a standard totem-pole logic output with a series Schottky diode
(1N5818,1N5819, or equivalent) or by pulling it low through an open-
collector transistor (no pull-up resistor). PWM/lO ADJ input voltages greater
than 0.3 V are not recommended and may create an unstable operating
condition.
TYPICAL FAN APPLICATION
MAGNETIC FIELD
DEFINITIONS
OUTA ON/LOW
S
+B
N
B=0G
+BO P
-B +B
-B O P
Dwg. AP-001-1
OUTB ON/LOW
Dwg. GP-008
By accepted magnetic convention, lines of flux emanate from the north pole of a magnet and enter the south pole.
115 Northeast Cutoff, Box 15036
Worcester, Massachusetts 01615-0036 (508) 853-5000
6 Page | ||
Seiten | Gesamt 8 Seiten | |
PDF Download | [ 3625 Schematic.PDF ] |
Teilenummer | Beschreibung | Hersteller |
3625 | POWERHALL SENSOR/DRIVERS FOR BRUSHLESS DC MOTORS | Allegro MicroSystems |
3628A | BIPOLAR PROM | Intel Corporation |
Teilenummer | Beschreibung | Hersteller |
CD40175BC | Hex D-Type Flip-Flop / Quad D-Type Flip-Flop. |
Fairchild Semiconductor |
KTD1146 | EPITAXIAL PLANAR NPN TRANSISTOR. |
KEC |
www.Datenblatt-PDF.com | 2020 | Kontakt | Suche |